1/20/2024 0 Comments Run sprutcam in virtualmachineThe letters that come to mind is KEF but nothing shows on google so i guess i remember wrong. it was built in the middle of the 80's somewhere and it has a fairly good repeatability of 0,1mm (for my use anyway). The manufacturer was german i belive and it was a three letter company (not kuka). I have been googling for model and make,But i cant remember the make. I will look into the documentation tomorrow. It is a 600V servo system with a +-10V signal(not PWM), but if i'm remembering correct it was mounted on a backbone of a bus of some kind. Please Log in or Create an account to join the conversation. I have absolutely no experience with rotating axes, will LinuxCNC translate and make my robotarm do G1 codes or does it need rotating codes to operate.Īnyone with any experience on this out there that could shine some light on capabilities of Linuxcnc and robotarm? But in order to make a 3Dprinter out of my robotarm i need to make it do streight lines in XYZ (G1-G3 mainly) basically run all the codes a XYZ machine do so great:) I'm doing some camwork on my old deckel(FP5NC) but mainy do 3Dprinter's, and it's regarding my 3Dprinting the need for a really big machine is emerging. I found after some minor googling that EMC2 could do this, since then you have gone from EMC name to Linuxcnc and a couple of years has passed. I hope i can make it run some kind of G-Code. Some while ago i stumbled upon a roboticarm (6axis), the prize was too good to let go of, so i ended up with it filling spce in my basement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |